• Previous
    DS04-NFC Servo 360-Degree Continuous Rotation Servo DC Gear Motor for Arduino/Raspberry-Pi/Robotics

16 Channel 12 Bit PWM and Servo Driver

In Stock
1,899.00
Product Code: RM3153

Delivered In: 15-20 Business Days

Description

16 Channel 12 Bit PWM and Servo Driver

16 Channel 12 Bit PWM and Servo Driver Features:
  • 5V Compliant - Means you can control it from a 3.3V microcontroller and still safely drive up to 6V outputs (this is good for when you want to control white or blue LEDs with 3.4+ forward voltages)
  • 6 Address Select Pins - Wire up to 62 of these on a single i2c bus, a total of 992 outputs - that's a lot of servos or LEDs
  • Adjustable frequency PWM up to about 1.6 KHz
  • 12-bit Resolution for Each Output - That means about 4us resolution at 60Hz update rate for servo's
  • Configurable push-pull or open-drain output
  • Output enable pin to quickly disable all the outputs
  • Terminal block for power input (or you can use the 0.1" breakouts on the side)
  • Reverse polarity protection on the terminal block input
  • Green power-good LED
  • 3 pin connectors in groups of 4 so you can plug in 16 servos at once (Servo plugs are slightly wider than 0.1" so you can only stack 4 next to each other on 0.1" header
  • "Chain-able" design
  • A spot to place a big capacitor on the V+ line (in case you need it)
  • 220 ohm series resistors on all the output lines to protect them, and to make driving LEDs trivial
  • Solder jumpers for the 6 address select pins

Downloads

Reviews (0)

Write a review

Note: HTML is not translated!
    Bad           Good
Note : Images shown is only for representation. The actual product may vary with the picture shown.