Wireless PS/2 Controller With 32 channel Servo Motor Driver for Arduino/Raspberry-Pi/Robotics

This is servo controller board with 32 channel can be control up to 32 servo motors at the same time, either by using a software on a PC, or UART communication (TTL serial port) of MCU (51, AVR, ARM, FPGA, PIC, etc.) to send commands to control the steering. You can also download instructions to the servo motor controller for offline operation. Wireless device compatible, it can also being set by the program we provided..

Features of Wireless PS/2 Controller With 32 channel Servo Motor Driver:

• Controlling MCU power supply: 6.5~12 V or 3.5~5.5V.
• Servos power supply: DC (depends on the motors, generally 5V DC).
• Control channels: 32.
• Communication Input: USB or UART (TTL or USART).
• Signal Output: PWM (Accuracy 1us).
• Servo motor resolution: 1us, 0.09 degrees.
• Baud Rate: 9600,19200,28400,57600,115200,128000(recognized automatically).
• Servo motors supported: Futaba, Hitec or some other Servo Motors controlled by PWM.
• Dimensions: 63.5mm x 43.5mm x 1.6mm.
• Control mode: USB and UART (TTL) to accept command. (Comes with USB data wire and PC controlling software**).
• Flash: on-board 512K ROM.
• Dimension : 63.5mm x 43.5mm x 1.6mm.

Applications of Wireless PS/2 Controller With 32 channel Servo Motor Driver:

• Open wireless receiver, solder with 7 dupont line according to the order of the picture showed.
• Connect 7 dupont line with the main board according to the order shown.
• Set up all buttons instructions of PS2 controller via computer software.

Note: Images shown is only for representation. The actual product may vary with the picture shown.

Also Searched as: wireless ps2 controller review, use wireless ps2 controller, search results for wireless ps2 controller, gamestop wireless ps2 controller problems, ps2 self wireless controller, sony ps2 wireless controller, how to connect ps2 wireless controller, ps2 nerf controller isp programmer for at89s51, isp programmer software free download.