ATmega8 Robotic Development Board V1.0

:The AVR ATmega8 development Board is ideal for learning AVR microcontrollers. This board contains requirements like LEDs, Switches, in system programming, RS232 communication, etc. All Ports of controller are accessible through standard 10 pin FRC connector or simple header pins. Also 34*11 general purpose area of normal grid is provided for extra development on the same board. This board supports many 40 pin controller. With all these features this board can be used to realize more than 35 working robotic projects.

Product Image of ATmega8 Robotic Development Board V1.0

Features of ATmega8 Robotic Development Board V1.0

• High-performance, Low-power Atmel®AVR® 8-bit Microcontroller.
• 8Kbytes of In-System Self-programmable Flash program memory.
• 512Bytes EEPROM.
• 1Kbyte Internal SRAM.
• Optional Boot Code Section with Independent Lock Bits.
• In-System Programming by On-chip Boot Program.
• Byte-oriented Two-wire Serial Interface.
• Programmable Serial USART.
• Master/Slave SPI Serial Interface.
• Programmable Watchdog Timer with Separate On-chip Oscillator.
• Operating Voltages.
• 5.0V - 24V.
• Power Consumption at 4Mhz, 3V, 25oC.
• Active: 3.6mA.
• Idle Mode: 1.0mA
• Power-down Mode: 0.5µA

Project of ATmega8 Robotic Development Board V1.0

• Blinking LED.
• Toggling LED.
• Line Follower.
• Edge avoider.
• Wall follower.
• Obstacle Avoider.
• Photo phobic.
• Photo Tropic.
• Clap operated Robotic car.
• Sound operated Home appliances control.
• Cell phone/Mobile operated Robotic car.
• Auto street light control.
• Mobile operated Home appliances controlled.
• Cell phone Controlled robot (DTMF Based).
• Line following Robot.
• Obstacle Avoiding Robot.
• Light Searching Robot.
• Edge Avoiding Robot.
• Clap operated Robotic car.
• Sound operated Home appliances control.
• Auto street light control.

KIT Content of ATmega8 Robotic Development Board V1.0

• 1x Atmega8 development board