• Previous
    Bare Flashing Card Set - Celebration Circuit
  • Next
    Electroluminescent (EL) Panel Starter Pack - 10cm x 10cm Aqua

EL wire welted piping starter pack - Aqua - 5 meters

In Stock
3,999.00
Product Code: RM3465

Delivered In: 25-30 Business Days

Description

EL wire welted piping starter pack - Aqua - 5 meters

A little bundle to get you started! This project pack contains:

  • 5 meters (over 16 ft) of welted EL wire piping in Aqua. 5 meters is the maximum amount for the pocket driver - it is cut and soldered so it's ready to go!
  • Pocket EL inverter runs on 2 AA Alkaline or rechargeable batteries (not included)
  • 2 inches of heat shink, both 1/8" and 1/4" for protecting the EL wire after soldering if you end up wanting to change the wire up
  • 2 inches of copper tape, used when soldering EL wire
  • 2 inches of foam tape, we use this to pad the inside of the inverter to quiet it down

We used EL wire to make our awesome TRON bag

Soldering to EL wire is a little tricky but luckily we wrote a detailed step-by-step tutorial!You'll need wire strippers, a soldering iron & solder, copper tape and heat shrink. A third-hand tool is really useful as well.

Downloads

Reviews (0)

Write a review

Note: HTML is not translated!
    Bad           Good
Note : Images shown is only for representation. The actual product may vary with the picture shown.
Check out this bundle:
Bundle price:
1,999.00

You save
50.00!