KKMulticopter Control Board V5.5
The KKmulticopter v5.5 board is a flight control board for remote control multicopters with 2,3,4 and 6 rotors. It’s purpose is to stabilize the aircraft during flight. To do this it takes the signal from the three gyros on the board (roll, pitch and yaw) and feeds the information into the Integrated Circuit (Atmega IC). This then processes the information according the KKmulticopter flash tool software and sends out a control signal to the Electronic Speed Controllers (ESC’s) which are plugged onto the board and also connected to the motors. Depending upon the signal from the IC the ESC’s will either speed up or slow down the motors (and tilt the rear rotor with a servo in a Tricopter) in order to establish level flight.
Features of KKMulticopter Control Board V5.5:
- Brand new & high quality.
- Easily Interfaceable.
- Programming through the programmer included.
- Auto tuning when connecting.
Applications of KKMulticopter Control Board V5.5:
- `It is used to control the flight for quadcopter
Note: Images shown is only for representation. The actual product may vary with the picture shown.Also Searched as: kkmulticopter control board v5.5 setup, kkmulticopter v5.5, kkmulticopter v5.5 programming, kkmulticopter quadcopter, kkmulticopter arduino, kkmulticopter control board v5.5 firmware, kkmulticopter control board v 5.5 with usb programmer, kkmulticopter control board v5.5 manual, kkmulticopter board, kkmulticopter controller
Note : Images shown is only for representation. The actual product may vary with the picture shown.