• Previous
    PCF8591 8-bit A/D - D/A converter for Arduino/Raspberry-Pi/Robotics
  • Next
    TQFP 32 To DIP 28 Prototyping Board for Arduino/Raspberry-Pi/Robotics

FT232RL FTDI USB TO TTL 5V 3.3V Convertor

In Stock
Product Code: RM2195

2-7 Business days


FT232RL FTDI USB TO TTL 5V 3.3V Convertor

The FT232RL is a USB to serial UART interface IC with the following advanced features:

  • Single chip USB to asynchronous serial data transfer interface.
  • Entire USB protocol handled on the chip. No USB specific firmware programming required.
  • Fully integrated 1024 bit EEPROM storing device descriptors and CBUS I/O configuration.
  • Fully integrated USB termination resistors.
  • Fully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGA.
  • Data transfer rates from 300 baud to 3 Mbaud (RS422, RS485, RS232) at TTL levels.
  • 128 byte receive buffer and 256 byte transmit buffer utilising buffer smoothing technology to allow for high data throughput.

Features of FT232RL USB TO TTL 5V 3.3V Convertor

  • Material: PCB + Electronic Component
  • Support 3.3V, 5V
  • Main Color: Red
  • Chipset: FT232RL
  • USB power has over current protection, using 500MA self-restore fuse
  • RXD/TXD transceiver communication indicator
  • Pin definition: DTR,RXD,TX,VCC,CTS,GND
  • Pitch:2.54mm
  • Module Size: About 36mm(length)*17.5mm(width)
  • Interface : Mini USB

NOTE: PC Interfacing Cable is not provided with this module


Reviews (0)

Write a review

Note: HTML is not translated!
    Bad           Good
Note : Images shown is only for representation. The actual product may vary with the picture shown.
Check out this bundle:
Bundle price:

You save